 |
Layout all 4 legs of one frame on a
small board...rabbit to rabbit.
(Also layout 4 "thumbnail inserts" for later) |
 |
Put glue in the thumbnail grooves and over entire
cut surface.
5 min setup
|
| Pick up a pair of legs and rub together
to smear glue evenly; set pieces down so they make a frame, rabbit side
up. Place the "thumbnail insert" into the groove and...
|
 |
 |
tap in with a hammer. |
| All 4 inserts must be in place at the end of 5 minutes from first applying the glue!! | |
 |
Wipe off any glue that appears to be white globs on the frame front AND |
 |
wipe clean the rabbit. You don't
want there to be a dried glob holding the glass from being flat! (screwdriver is a handy tool for precision glue removal) |
 |
Cure for 3 hours by laying frame flat. You can lay frames on top of one another. If one doesn't want to lay flat, apply a weight. |
|
GOTO Fill and Sand the Corners-Pt 4 |
|